Sunday, April 25, 2010

20 WATT FLUORO INVERTER used tip3055

20 WATT FLUORO INVERTER used tip3055
This circuit will drive a 40 watt fluoro or two 20watt tubes in series.
The transformer is wound on a ferrite rod 10mm dia and 8cm long.
The wire diameters are not critical but our prototype used 0.61mm wire for the primary and 0.28mm wire for the secondary and feedback winding.
Do not remove the tube when the circuit is operating as the spikes produced by the transformer will damage the transistor.
The circuit will take approx 1.5amp on 12v, making it more efficient than running the tubes from the mains. A normal fluoro takes 20 watts for the tube and about 15 watts for the ballast.
source : http://talkingelectronics.com/projects/200TrCcts/200TrCcts.html
Load disqus comments

0 comments