Sunday, July 29, 2007

Soft-Start Circuit For Power Amps

When your monster (or not so monster) power amplifier is switched on, the initial current drawn from the mains is many times that even at full power. There are two main reasons for this, as follows ...

  • Transformers will draw a very heavy current at switch on, until the magnetic flux has stabilised. The effect is worst when power is applied as the AC voltage passes through zero, and is minimised if power is applied at the peak of the AC waveform. This is exactly the opposite to what you might expect
  • At power on, the filter capacitors are completely discharged, and act as a short circuit for a brief (but possibly destructive) period
These phenomena are well known to manufacturers of very high power amps used in PA and industrial applications, but 'soft start' circuits are not commonly used in consumer equipment. Anyone who has a large power amp - especially one that uses a toroidal transformer - will have noticed a momentary dimming of the lights when the amp is powered up. The current drawn is so high that other equipment is affected.

READ MORE ...
Load disqus comments

0 comments